Cobra

STEP 01

Hold a sheet of paper in portrait orientation and fold in half (lengthways) along the line shown in DIG. 1 then open out again.

STEP 02

Now fold in the top left and top right corners of the paper to the centre line as shown in DIG. 2.

STEP 03

Fold down the tip of the plane to the centre of the bottom of the top triangle. This fold is shown by an arrow in DIG. 3.

STEP 04

Now comes the first tricky bit. Open up the paper to it’s original form so that the dotted lines shown in DIG. 4 mark out the creased lines on the paper.

STEP 05

Now pull in the corners and top centre of the paper along the arrows shown in DIG. 4 so that the plane passes through the step shown in DIG. 5. The plane should fall relatively comfortably into the form shown in DIG. 5 due to the existing creases.

STEP 06

Fold down the trapezium shape at the top of DIG. 6 along the bottom edge of the folded down paper. There are little dotted indicators at each end of the line in DIG. 6 to indicate which line to fold along

STEP 07

Now fold and unfold as indicated by the arrows on DIG. 7. This involves folding the top left and right corners into the centre line of the plane at the bottom of the flap folded down in the previous step.

STEP 08

Flip over the plane and fold in the opposite direction along the creases created in the previous step then unfold as indicated by the arrows in DIG. 8.

STEP 09

Follow the diagram above.

STEP 10

The top left and right corners (labelled A and B) must now be tucked under the flap formed in step 7 (coloured in red) so that they meet at the centre line of the plane at the bottom edge of that flap. The labels are shown in DIG. 9 and the folding should pass through the form shown in DIG. 10 where the red arrows indicate pressure being applied. The positions the arrows are applying pressure to are the corners labelled A and B.

STEP 11

Dobla el plane in half along the centre line in DIG. 11 keeping all the folded sections on the outside when folding.

STEP 12

Follow the diagram above.

STEP 13

Fold down the wings along the dotted lines indicated in DIG. 12 and DIG. 13 to give the form shown in DIG. 14 then open up to give the plane as shown at the top of the page.

STEP 14

Follow the diagram above.